Search MHK Data

TEAMER: Advanced Wave-to-Wire OWC model in WEC-Sim

Accurate numerical models are crucial for the development of wave energy converter (WEC) technologies, providing the means for power production and lifetime assessment, site selection, and design of mooring lines, PTO systems and controllers, among other aspects. This project aims...

Peñalba, M. et al Mondragon Goi Eskola Politeknikoa

Dec 20, 2024
5 Resources
0 Stars
Curated

TEAMER: Experimental Validation and Analysis of Deep Reinforcement Learning Control for Wave Energy Converters

Through this TEAMER project, Michigan Technological University (MTU) collaborated with Oregon State University (OSU) to test the performance of a Deep Reinforcement Learning (DRL) control in the wave tank. Unlike model-based controls, DRL control is model-free and can directly max...

Zou, S. et al Michigan Technological University

Mar 07, 2025
7 Resources
0 Stars
Curated

TEAMER: FOSWEC Mooring Modeling and Analysis, Post Access Report and Data

Floating oscillating surge wave energy converters (FOSWECs) offer several advantages over bottom-hinged oscillating surge wave energy converters, including large wave potential at deep-water sites with fewer permitting and environmental concerns outside territorial waters. As a te...

Housner, S. et al Virginia Tech

Jun 14, 2022
10 Resources
0 Stars
Publicly accessible

TEAMER: Cross-flow Turbine Hydrodynamics

The objective of this work is to validate RANS and LES computations of cross-flow turbine hydrodynamics using laboratory scale measurements. Validation involves the comparison of time-and phase averaged performance metrics and flowfields across the widest practical range of turbin...

Athair, A. et al University of Washington (NNMREC)

Mar 25, 2025
7 Resources
0 Stars
Curated

TEAMER: AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation, Sim Model

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
6 Resources
0 Stars
Publicly accessible

TEAMER AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation, Test Logs and Results

Hagmuller, A. et al AquaHarmonics, Inc.

Dec 16, 2021
10 Resources
0 Stars
Curated

TEAMER: Experimental Characterization of a Laboratory-Scaled Oscillating Surge Wave Energy Converter

This data is a result of an experimental campaign to characterize the hydrodynamics and performance of a laboratory-scale oscillating surge wave energy converter (OSWEC). The device was 85 cm wide, 1.4 meters tall, and 14 cm thick and was tested in the Sea Wave Environmental Lab (...

Lydon, B. et al University of Washington

Apr 05, 2024
9 Resources
0 Stars
Curated

TEAMER: Sandia Lake Calibration Videos of Wave Powered Oceanographic Glider Navigation System

These are video recordings and photographs captured during testing of the Wave Powered Oceanographic Glider (WPOG) navigation system at the Sandia National Laboratories lake facility. The tests were conducted as part of a TEAMER project led by Moye Consultants to evaluate depth co...

Moye, D. et al Moye Consultants

Jul 09, 2025
3 Resources
0 Stars
Curated

TEAMER: OpenFAST Modeling and Simulation of the Aquantis AQ10 Marine Hydrokinetic Turbine

This dataset was developed under TEAMER technical support (CRD-21-17763-0) to model the Aquantis AQ10, a spar buoy-based marine hydrokinetic turbine, using the OpenFAST simulation framework. The project transitioned modeling from the proprietary Tidal Bladed tool to OpenFAST to en...

Swales, H. and Tran, T. Aquantis, Inc.

Jul 31, 2025
3 Resources
1 Stars
Curated

TEAMER: Modeling, Optimization, and Design Data for a Bio-Inspired Wave Energy Converter

This dataset contains modeling files, computational results, and analysis reports from work focused on the initial optimization and design of a bio-inspired Wave Energy Converter (WEC). Data were produced using tools including WEC-Sim and WecOptTool, with supporting scripts and mo...

Grasberger, J. et al Sandia National Laboratories

Jul 14, 2025
2 Resources
0 Stars
Curated

TEAMER: Performance Enhancement Testing and Dynamic Design Optimization of a Vertical Axis Hydrokinetic Turbine

This work was conducted at the University of Washington in collaboration with Emrgy, Inc. with support from TEAMER. The University of Washington deployed multiple physical scale models of potential future design aspects in their Alice C. Tyler test flume. From this research, the i...

Talpey, G. et al University of Washington

Dec 10, 2024
3 Resources
0 Stars
Curated

TEAMER: A Tow Body Optical Camera System

Archive consists of design drawings, assembly instructions, and bill of materials (BOM) for a Igiugig Village Council (IVC)/Ocean Renewable Power company (ORPC) tow body camera system for underwater environmental monitoring using optical cameras. This work was conducted by the Uni...

Joslin, J. et al University of Washington

Apr 30, 2021
6 Resources
1 Stars
Publicly accessible

TEAMER: Results of Investigating Structural Design Concepts and Alternative Materials for a Wave Power System

Included here are materials from a study on the design of a three-body Wave Energy Converter (WEC) utilizing a heave plate, dual Power Take Offs (PTOs), and single point mooring. A material trade study has been conducted to evaluate the effects of introducing various metallic and ...

Whitney, C. et al Cardinal Engineering

Apr 27, 2024
4 Resources
0 Stars
Awaiting release

TEAMER: Investigation of Alternate Material Design Methods in WPS Ballast and Hull Systems

Data, results and final report from a study on the use of alternative materials in a floating, two-body Wave Power System (WPS). This study was focused on introduction of fiber-reinforced polymer and concrete in structural elements of the subject WPS, as well as the design and per...

Veilleux, M. et al Cardinal Engineering

Apr 22, 2025
3 Resources
1 Stars
Curated

TEAMER: Triton Systems Oscillating Water Column Modeling Data and Report

This dataset provides the output of six Wave Energy Converter Simulator (WEC-Sim) simulations and accompanying documentation for the modeling of Triton Systems' oscillating water column (OWC) system at tank scale (validated using available data for tuning the model, Tests 1-2) and...

Forbush, D. et al Sandia National Laboratories

Aug 30, 2024
3 Resources
0 Stars
Awaiting release

TEAMER: Numerical Modeling of the Pitching Inertial Pump (PIP) Wave Energy Capture Device

This project focused on further development of a Numerical Model of the iProTech Pitching Inertial Pump (PIP) wave energy converter (WEC) using the MATLAB/Simulink tool, WEC-Sim. The process involved parameterizing key design variables, running time-domain simulations, and perform...

Wynn, N. et al IProTech

Feb 26, 2026
1 Resources
0 Stars
Curated

TEAMER: CalWave UMaine 2021 Tank Testing

This is the data submission to the teamer report for RFTS 1 (request for technical support) during which tank testing at UMaine W2 tank occurred. This submission includes the relevant information and recorded data of CalWave's UMaine wave tank testing conducted under TEAMER Reques...

Boerner, T. CalWave Power Technologies Inc.

Apr 01, 2021
1 Resources
0 Stars
Awaiting release

TEAMER: Additional Degree of Freedom for WEC Model

'Additional Degree of Freedom for WEC' WEC-Sim numerical model from RFTS 1 (request for technical support) TEAMER project. An increase in wave energy converter (WEC) efficiency requires not only consideration of the nonlinear effects in the WEC dynamics and the power take-off (PTO...

McCall, A. et al Dehlsen Associates, LLC

May 26, 2022
2 Resources
0 Stars
Awaiting release

TEAMER RFTS-10 Modular Group Helical Pile Anchor Structural Analysis

The Modular Group Helical Pile Anchor Structural Analysis project aimed to evaluate and optimize the anchor?s structural performance, fatigue resistance, and load distribution through finite element analysis (FEA) and advanced computational modeling. The study covered finite eleme...

Lopez, C. et al Stress Engineering Services, Inc.

Mar 20, 2026
8 Resources
0 Stars
Awaiting curation

TEAMER: Numerical Modeling and Optimization of the iProTech Pitching Inertial Pump (PIP) Wave Energy Converter (WEC)

This project focused on developing an automated workflow to evaluate and optimize the iProTech Pitching Inertial Pump (PIP) wave energy converter (WEC) using open-source Python packages and the MATLAB/Simulink tool, WEC-Sim. The process involved parameterizing key design variables...

Wynn, N. et al National Renewable Energy Laboratory

Apr 11, 2024
2 Resources
0 Stars
Curated

TEAMER: Laboratory Upgrade Point Absorber v2 CAD Model and Bill of Materials

The Laboratory Upgrade Point Absorber (LUPA) is an open-source wave energy converter designed and tested by Oregon State University. The computer-aided design (CAD) files are provided here in two forms: the original SOLIDWORKS (2024) model as "LUPA SOLIDWORKS.zip" and as a STEP fi...

Robertson, B. et al Oregon State University

Apr 22, 2025
9 Resources
0 Stars
Curated

TEAMER: Optimization of a Wave Power System (WPS) Structure and Interfaces for Generator Integration

Data, results, and final report from a study on methods to structurally integrate permanent magnet generator (PMG) variants within a floating, two-body Wave Power System (WPS). This study also demonstrated the incorporation of a novel Localized Airgap Reduction System (LARS), whic...

Batol, D. et al Cardinal Engineering

Nov 24, 2025
11 Resources
0 Stars
Curated

TEAMER: Initial Testing of Wave Energy-Powered UV-C LED Anti-Biofouling System, Post-Access Report, 3newable LLC

Biofouling severely limits the quality of data coming from buoy-mounted sensors. 3newable is co-developing a unique solution to the biofouling problem together with the Ocean Observatories Initiative (OOI) at WHOI to design and build a buoy-mounted WEC as an integrated power sourc...

Minsky, M. et al 3newable LLC

Sep 20, 2022
2 Resources
0 Stars
Publicly accessible

TEAMER: Cook Inlet Tidal Survey at Hilcorp Platforms

Acoustic Doppler Current Profiler (ADCP) ebb and flow tidal measurements were collected to characterize tidal hydrodynamics in the vicinity of offshore platform structures. Observations include both stationary bottom-mounted deployments and vessel-based transects, enabling resolut...

DUVOY, P. and Loeffler, B. University of Alaska Fairbanks

Jan 28, 2025
15 Resources
0 Stars
Curated

TEAMER: Two Stage Ocean Current Turbine Reduced Order Modeling

The Equinox Ocean Current turbine is a groundbreaking new two-stage turbine design, enabling cost effective power generation at low water velocities. The data included in this submission can be used to reproduce the figures provided in the corresponding Post Access Report. The pro...

Ross, H. et al National Laboratory of the Rockies

Mar 04, 2026
2 Resources
0 Stars
Curated

1 2 Next >>