Search MHK Data

Northwest National Marine Renewable Energy Center, OR Project Plans

Plans for Northwest National Marine Renewable Energy Center (NNMREC) Project. Mobile Ocean Test Berth (MOTB) plans PMEC-SETS Plans

Hellin, D. Northwest National Marine Renewable Energy Center

Jun 29, 2016
20 Resources
0 Stars
Curated

TEAMER: Investigation of Alternate Material Design Methods in WPS Ballast and Hull Systems

Data, results and final report from a study on the use of alternative materials in a floating, two-body Wave Power System (WPS). This study was focused on introduction of fiber-reinforced polymer and concrete in structural elements of the subject WPS, as well as the design and per...

Veilleux, M. et al Cardinal Engineering

Apr 22, 2025
3 Resources
1 Stars
Curated

SeaRAY WEC Preliminary Design and Test Planning

The SeaRAY is a deployable power system for maritime sensors, monitoring equipment, communications, unmanned underwater vehicles, and other similar payloads. This project is to design, deliver, and test a prototype low-power WEC that lowers the total cost of ownership and provides...

Hammagren, E. et al Columbia Power Technologies, Inc.

May 18, 2020
4 Resources
0 Stars
Awaiting release

2023 Risk Management Plan and Register for Low-Power WEC for Non-Grid Applications

This is an updated risk management plan and risk register for the design, build and test of a novel, remote, low-power wave energy converter (WEC) for non-grid applications. This Columbia Power Technologies project seeks to develop a prototype low-power WEC that lowers the total c...

Hammagren, E. et al Columbia Power Technologies, Inc.

Jun 14, 2023
17 Resources
0 Stars
Awaiting release

StingRAY Failure Mode, Effects and Criticality Analysis: WEC Risk Registers

Analysis method to systematically identify all potential failure modes and their effects on the Stingray WEC system. This analysis is incorporated early in the development cycle such that the mitigation of the identified failure modes can be achieved cost effectively and efficient...

Rhinefrank, K. Columbia Power Technologies, Inc.

Jul 25, 2016
18 Resources
0 Stars
Publicly accessible

TEAMER: AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation, Sim Model

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
6 Resources
0 Stars
Publicly accessible

Triton Point Absorber 1:30 Scale Tank Test Data for Extreme Wave Environments

This content model summarizes laboratory testing data for the Oscilla Power Triton WEC conducted at 1:30 scale. The WEC was tested in large operational waves and in extreme wave conditions along the 1 in 50 year wave contour at the DoE reference location in Humbolt Bay, CA. The WE...

Mundon, T. and Rosenberg, B. Oscilla Power, Inc.

Mar 13, 2018
26 Resources
0 Stars
Publicly accessible

RANS Simulation VBM of Single Lab Scaled DOE RM1 MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single lab-scaled DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. The lab-scaled DOE RM1 is a re-design geometry, based of the full scale DOE RM1 design, producing same po...

Javaherchi, T. et al University of Washington (NNMREC)

Apr 15, 2014
8 Resources
0 Stars
Publicly accessible

RANS Simulation VBM of Single Full Scale DOE RM1 MHK Turbine

Attached are the .cas and .dat files along with the required User Defined Functions (UDFs) and look-up table of lift and drag coefficients for Reynolds Averaged Navier-Stokes (RANS) simulation of a single full scale DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this...

Javaherchi, T. and Aliseda, A. University of Washington

Apr 10, 2013
8 Resources
0 Stars
Publicly accessible

Reference Model 6 Full Scale Geometry (RM6: Oscillating Water Column)

Contains the Reference Model 6 (RM6) full scale geometry files of the Oscillating Water Column, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. This data was g...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
4 Resources
0 Stars
Publicly accessible

RANS Simulation VBM of Array of Three Coaxial Lab Scaled DOE RM1 MHK Turbine with 5D Spacing

Attached are the .cas and .dat files along with the required User Defined Functions (UDFs) and look-up table of lift and drag coefficients for the Reynolds Averaged Navier-Stokes (RANS) simulation of three coaxially located lab-scaled DOE RM1 turbine implemented in ANSYS FLUENT CF...

Javaherchi, T. University of Washington

Jun 08, 2016
9 Resources
0 Stars
Publicly accessible

Reference Model 5 Full Scale Geometry (RM5: Oscillating Surge Flap)

Contains the Reference Model 5 (RM5) full scale geometry files of the Oscillating Surge Flap, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. This data was gen...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
5 Resources
0 Stars
Publicly accessible

Next Generation RivGen Power System: Feasibility Assessment of Hydroacoutics Data for Development of a Probability of Encounter Model of Salmon Smolts

This document contains a feasibility assessment for salmon smolt characterization and analysis based on existing hydroacoustics data and probability of encounter model.

Daroux, A. and Zydlewski, G. Igiugig Village Council

Oct 04, 2017
1 Resources
0 Stars
Publicly accessible

State Estimation for advanced control of wave energy converters

A report on state estimation for advanced control of wave energy converters (WECs), with supporting data models and slides from the overview presentation. The methods discussed are intended for use to enable real-time closed loop control of WECs.

Coe, R. and Bacelli, G. Sandia National Laboratories

Apr 25, 2017
6 Resources
0 Stars
Publicly accessible

RANS Simulation RRF of Single Full Scale DOE RM1 MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single full scale DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this case study taking advantage of the symmetry of the DOE RM1 geometry, only half of the geometry i...

Javaherchi, T. et al University of Washington

Apr 10, 2013
2 Resources
0 Stars
Publicly accessible

TEAMER: FOSWEC Mooring Modeling and Analysis, Post Access Report and Data

Floating oscillating surge wave energy converters (FOSWECs) offer several advantages over bottom-hinged oscillating surge wave energy converters, including large wave potential at deep-water sites with fewer permitting and environmental concerns outside territorial waters. As a te...

Housner, S. et al Virginia Tech

Jun 14, 2022
10 Resources
0 Stars
Publicly accessible

TEAMER: Long Island Sound Tidal Resource Assessment Geodatabase Model

This submission includes the Long Island Sound (LIS) Tidal Energy Resource Geodatabase developed collaboratively by Integral Consulting Inc. and Future Island Impact (FII) as part of a TEAMER-supported pre-feasibility study. The geodatabase is provided as a QGIS project and includ...

Flanary, C. and Tanguay, N. Integral Consulting Inc.

Jul 10, 2025
3 Resources
0 Stars
Curated

RANS Simulation ADM of the NREL Phase VI wind turbine modeled as MHK Turbine

Attached are the .cas and .dat files for the Reynolds Averaged Navier-Stokes (RANS) simulation of a single lab-scaled DOE RM1 turbine implemented in ANSYS FLUENT CFD-package. In this case study the flow field around and in the wake of the NREL Phase VI wind turbine, modeled is MH...

Javaherchi, T. University of Washington

Jun 08, 2016
3 Resources
0 Stars
Publicly accessible

Modeling and Performance Data for Heaving Buoy Wave Energy Converter with a Compressible Degree of Freedom (CDOF)

Modeling and performance data in Matlab data file (.mat) containing 3 structures (WEC model, simRes_sr and simRes_fix), and a pdf document describing the model, the simulations, and the analysis that has been carried out.

Bacelli, G. Sandia National Laboratories

Sep 28, 2016
2 Resources
0 Stars
Publicly accessible

Azura Advanced Controls 1/15th Scale Wave Tank Testing

Experimental data from the wave tank test of the Advanced control systems developed by Northwest Energy Innovations (NWEI) for the Azura at the University of Maine in Orono (UMO). Summary data is included utilizing the WEC Lab Testing Content Model v2.1. All raw and processed expe...

Ling, B. Northwest Energy Innovations

Feb 02, 2018
10 Resources
0 Stars
Publicly accessible

TEAMER: Advanced Wave-to-Wire OWC model in WEC-Sim

Accurate numerical models are crucial for the development of wave energy converter (WEC) technologies, providing the means for power production and lifetime assessment, site selection, and design of mooring lines, PTO systems and controllers, among other aspects. This project aims...

Peñalba, M. et al Mondragon Goi Eskola Politeknikoa

Dec 20, 2024
5 Resources
0 Stars
Curated

TEAMER: Supporting model output files for Environmental Compliance Framework for Floating Tidal Turbines, Cook Inlet, AK

Orbital Marine Power (Orbital) is seeking to deploy their floating tidal technology in US waters and has considered the possibility of deploying in temperate waters including the Pacific Northwest (PNW) and the Western Passage, Maine. It has become apparent that some of the most p...

Wang, T. et al Pacific Northwest National Laboratory

Mar 01, 2023
5 Resources
0 Stars
Publicly accessible

Numerical Analysis of Two-Body Floating Attenuator WEC (Waveberg)

This TEAMER RFTS 9 award was used to develop a numerical model of the Waveberg floating attenuator wave energy converter (WEC) using the Wave Energy Converter-Simulator (WEC-Sim). The Waveberg is designed to generate power in the smaller waves (for wave heights of 1 2 meters) pred...

Wegener, P. DBA Waveberg Development

Mar 26, 2025
16 Resources
0 Stars
In curation

RivGen Deployment Control System Specifications and Models, Igiugig, AK

Control System simulation models, case studies, and processing codes for analyzing field data. Raw data files included from VFD and SCADA. MatLab and Simulink are required to open some data files and all model files.

Forbush, D. et al Ocean Renewable Power Company

Mar 21, 2016
2 Resources
0 Stars
Publicly accessible

TEAMER: Triton Systems Oscillating Water Column Modeling Data and Report

This dataset provides the output of six Wave Energy Converter Simulator (WEC-Sim) simulations and accompanying documentation for the modeling of Triton Systems' oscillating water column (OWC) system at tank scale (validated using available data for tuning the model, Tests 1-2) and...

Forbush, D. et al Sandia National Laboratories

Aug 30, 2024
3 Resources
0 Stars
Awaiting release

<< Previous 1 2 3 4 5 6 Next >>