Search MHK Data

TEAMER: AquaHarmonics High Fidelity WEC Sim PTO and Control Model Validation, Sim Model

Collaborative effort between AquaHarmonics, Sandia National Laboratories (SNL), and the National Renewable Energy Laboratory (NREL) to revise and validate Aquaharmonics' full wave to wire model, allowing for reduced uncertainty and increased understanding of design requirements of...

Tom, N. and Leon, J. AquaHarmonics, Inc.

Dec 31, 2021
6 Resources
0 Stars
Curated

Wave Tank Testing Report for Controls Validation of a Heaving Point Absorber

The core objectives of this project is to improve the power capture of three different wave energy conversion (WEC) devices by more than 50% using an advanced control system and validate the attained improvements using wave tank and full scale testing. In parallel, we will bring a...

Previsic, M. et al Re Vision Consulting

Aug 26, 2020
3 Resources
0 Stars
Publicly accessible

TEAMER: FOSWEC Mooring Modelling and Analysis, Post Access Report and Data

Floating oscillating surge wave energy converters (FOSWECs) offer several advantages over bottom-hinged oscillating surge wave energy converters, including large wave potential at deep-water sites with fewer permitting and environmental concerns outside territorial waters. As a te...

Housner, S. et al Virginia Tech

Jun 14, 2022
13 Resources
0 Stars
Curated

CalWave Revised IO&M Plan CalWave Open Water Demo

Revised IO&M Plan for CalWave's open water demonstration at Scripps Institution of Oceanography for the open water demonstration to be conducted in collaboration with University of California, San Diego (UCSD) near the Scripps Institute of Oceanography (SIO) pier, in a water dept...

Petcovic, D. et al CalWave Power Technologies Inc.

Jun 02, 2020
1 Resources
0 Stars
Awaiting release

Specified System Requirements for the HydroAir Power Take Off System

Includes Annual Energy Production of the system, Target Availability of the system, the system's PWR (power to weight ratio), Critical Dimensions and Weights (e.g. center of gravity and center of buoyancy, capture length) of the system, the system's Noise Levels, and All Grid Requ...

Natanzi, S. and Hall, R. Siemens Government Technologies, Inc.

Oct 02, 2020
1 Resources
0 Stars
Awaiting release

Performance estimation of resonance-enhanced dual-buoy wave energy converter using coupled time-domain simulation

This paper presents the modeling methodology and performance evaluation of the resonance-enhanced dual-buoy WEC (Wave Energy Converter) by HEM (hydrodynamic & electro-magnetic) fully-coupled-dynamics time-domain-simulation program. The numerical results are systematically compared...

Kang, H. et al Texas A&M University

Aug 31, 2020
3 Resources
0 Stars
Publicly accessible

Risk Management Plan and Risk Register for Design Low-Power Wave Energy Converter for Non-Grid Applications

Risk Registers for major subsystems completed according to the methodology described in the Risk Management Plan [DE-EE0008627 D1.2 Risk Management Plan PD v1.1 07-19-2019.pdf], also included here.

Amon, E. Columbia Power Technologies, Inc.

Jul 19, 2019
17 Resources
0 Stars
Awaiting release

Timeseries Data from the Experimental Testing of the OPI's Prototype Hydraulic Drivetrain.

Timeseries data from the experimental testing of the OPI's prototype hydraulic drivetrain. The data is provided in .mat file format. The units for the data can be found in the ReadMe included in the submission resources.

Mundon, T. Oscilla Power, Inc.

Nov 26, 2021
4 Resources
0 Stars
Awaiting release

Control-based optimization for tethered tidal kite

This submission includes three peer-reviewed (under review) papers from the researchers at North Carolina State University presenting control-based techniques to maximize effectiveness of a tethered tidal kite. Below are the abstracts of each file included in the submission. Cobb...

Vermillion, C. et al North Carolina State University

Mar 02, 2020
3 Resources
0 Stars
Publicly accessible

Modeling and Performance Data for Heaving Buoy Wave Energy Converter with a Compressible Degree of Freedom (CDOF)

Modeling and performance data in Matlab data file (.mat) containing 3 structures (WEC model, simRes_sr and simRes_fix), and a pdf document describing the model, the simulations, and the analysis that has been carried out.

Bacelli, G. Sandia National Laboratories

Sep 28, 2016
2 Resources
0 Stars
Publicly accessible

NWEI Azura RTI 1/20th Model Validation Wave Tank Test Data

Data from the 1/20th wave tank test of the RTI model. Northwest Energy Innovations (NWEI) has licensed intellectual property from RTI, and modified the PTO and retested the 1/20th RTI model that was tested as part of the Wave Energy Prize. The goal of the test was to validate NWEI...

Ling, B. and Lettenmaier, T. Northwest Energy Innovations

May 08, 2017
7 Resources
0 Stars
Publicly accessible

SeaRAY WEC Preliminary Design and Test Planning

The SeaRAY is a deployable power system for maritime sensors, monitoring equipment, communications, unmanned underwater vehicles, and other similar payloads. This project is to design, deliver, and test a prototype low-power WEC that lowers the total cost of ownership and provides...

Hammagren, E. et al Columbia Power Technologies, Inc.

May 18, 2020
4 Resources
0 Stars
Awaiting release

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...

Previsic, M. and Karthikeyan, A. Re Vision Consulting

Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

StingRAY Failure Mode, Effects and Criticality Analysis: WEC Risk Registers

Analysis method to systematically identify all potential failure modes and their effects on the Stingray WEC system. This analysis is incorporated early in the development cycle such that the mitigation of the identified failure modes can be achieved cost effectively and efficient...

Rhinefrank, K. Columbia Power Technologies, Inc.

Jul 25, 2016
18 Resources
0 Stars
Publicly accessible

2023 Risk Management Plan and Register for Low-Power WEC for Non-Grid Applications

This is an updated risk management plan and risk register for the design, build and test of a novel, remote, low-power wave energy converter (WEC) for non-grid applications. This Columbia Power Technologies project seeks to develop a prototype low-power WEC that lowers the total c...

Hammagren, E. et al Columbia Power Technologies, Inc.

Jun 14, 2023
17 Resources
0 Stars
Awaiting release

TEAMER: Results of Investigating Structural Design Concepts and Alternative Materials for a Wave Power System

Included here are materials from a study on the design of a three-body Wave Energy Converter (WEC) utilizing a heave plate, dual Power Take Offs (PTOs), and single point mooring. A material trade study has been conducted to evaluate the effects of introducing various metallic and ...

Whitney, C. et al Cardinal Engineering

Apr 27, 2024
4 Resources
0 Stars
Curated

MASK4 Test Campaign for Sandia WaveBot Device Dataset

This data and report details the findings from a wave tank test focused on production of useful work of a wave energy converter (WEC) device. The experimental system and test were specifically designed to validate models for power transmission throughout the WEC system. Additional...

Forbush, D. et al Sandia National Laboratories

Dec 25, 2023
5 Resources
0 Stars
Curated

Reference Model 6 Full Scale Geometry (RM6: Oscillating Water Column)

Contains the Reference Model 6 (RM6) full scale geometry files of the Oscillating Water Column, developed by the Reference Model Project (RMP). These full scale geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. This data was g...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
4 Resources
0 Stars
Publicly accessible

TEAMER: Biofouling Analysis for Wave Energy Piston Design Load Cell Data

Biofouling and corrosion are a major concern for all ocean-deployed components, especially when mechanical motion is involved. Triton has developed the concept of a biofouling mitigation seal as part of the piston sealing assembly for the Triton Wave Energy Converter (TSI-WEC). Th...

Robertson, T. et al Triton Systems, Inc.

Nov 01, 2021
9 Resources
0 Stars
Publicly accessible

HERO WEC V1 Upgrade 2023 Laboratory Testing (processed data)

The following submission includes processed laboratory data from NREL's Hydraulic and Electric Reverse Osmosis Wave Energy Converter (HERO WEC), in the form of MATLAB workspaces. This dataset was created using NREL's Large Amplitude Motion Platform (LAMP) and collected between Aug...

Panzarella, J. et al National Renewable Energy Laboratory

Jan 01, 2024
8 Resources
0 Stars
Publicly accessible

Focusing Wave Energy for Wave Energy Converter Applications

Wave tank tests at Stevens Institute of Technology quantified the ability of near-surface platforms to concentrate wave energy over the platform. Due to the instantaneous change in water depth, mass, energy, and power are conserved in this process. The energy and power concentrat...

Raftery, M. Martin and Ottaway

Aug 10, 2010
7 Resources
0 Stars
Publicly accessible

H3 StingRAY Final Design and Technical Report Section 13 Appendices

These documents are referenced in the public version of the H3 StingRAY Final Design and Technical Report (Linked Dataset can be found in Resources section, below), and are submitted separately to allow for public release of head document. The display names have the corresponding ...

Lenee-Bluhm, P. and Prudell, J. Columbia Power Technologies, Inc.

Sep 15, 2023
53 Resources
0 Stars
Awaiting release

<< Previous 1 2