Search MHK Data

TEAMER: MADWEC Techno-Economic Analysis

The objective of this project was for the facility to conduct a techno-economic assessment (TEA) of the Maximal Asymmetric Drag Wave Energy Converter (MADWEC), developed by the University of Massachusetts Dartmouth (UMass Dartmouth). MADWEC is used for powering remote monitoring a...

Ortega, T. and Baca, E. National Renewable Energy Laboratory

Mar 08, 2024
2 Resources
0 Stars
Publicly accessible

Advanced Direct-Drive Generator for Improved Availability of Oscillating Wave Surge Converter Power Generation Systems: 10hp 30rpm Radial-Flux Magnetically Geared Generator Test Data

Static torque, no load, constant speed, and sinusoidal oscillation test data for a 10hp, 300rpm magnetically-geared generator prototype using either an adjustable load bank for a fixed resistance or an output power converter.

Ouyang, W. and Tchida, C. ABB Inc.

May 02, 2017
1 Resources
0 Stars
Publicly accessible

TEAMER: Drifting Hydrophone System Block Diagram and Pre-Amplifier Calibrations

This data release is part of TEAMER RFTS 2, where the Cooperative Institute for Marine Resources Studies (CIMRS) at Oregon State University is performing hardware and software development and integration of four newly designed drifting hydrophone systems for underwater noise measu...

Turnbull, J. et al Pacific Marine Energy Center (PMEC)

Feb 26, 2024
3 Resources
0 Stars
Curated

2023 Risk Management Plan and Register for Low-Power WEC for Non-Grid Applications

This is an updated risk management plan and risk register for the design, build and test of a novel, remote, low-power wave energy converter (WEC) for non-grid applications. This Columbia Power Technologies project seeks to develop a prototype low-power WEC that lowers the total c...

Hammagren, E. et al Columbia Power Technologies, Inc.

Jun 14, 2023
17 Resources
0 Stars
Awaiting release

StingRAY Failure Mode, Effects and Criticality Analysis: WEC Risk Registers

Analysis method to systematically identify all potential failure modes and their effects on the Stingray WEC system. This analysis is incorporated early in the development cycle such that the mitigation of the identified failure modes can be achieved cost effectively and efficient...

Rhinefrank, K. Columbia Power Technologies, Inc.

Jul 25, 2016
18 Resources
0 Stars
Publicly accessible

TEAMER: Numerical Modeling of WECs to Support OES Task 10

This submission contains the files for reproducing the waves only and sphere test article simulations for the experimental setup (three different wave conditions) associated with the Teamer Request for Technical Support 9 (RFTS 9) fluid dynamics simulations to support the Ocean En...

Meuris, B. et al Sandia National Laboratories

Sep 23, 2024
1 Resources
0 Stars
Publicly accessible

Drifting Acoustic Measurements around C-Power's SeaRay WEC

The repository contains underwater noise measurements and associated metadata collected around C-Power's SeaRay wave energy converter on July 15, 2024 and July 16, 2024 while it was deployed at the U.S. Navy's Wave Energy Test Site (WETS) in Kaneohe, HI. Measurements were obtained...

Polagye, B. et al University of Washington

Jul 16, 2024
2 Resources
1 Stars
Publicly accessible

TEAMER: Biofouling Analysis for Wave Energy Piston Design Load Cell Data

Biofouling and corrosion are a major concern for all ocean-deployed components, especially when mechanical motion is involved. Triton has developed the concept of a biofouling mitigation seal as part of the piston sealing assembly for the Triton Wave Energy Converter (TSI-WEC). Th...

Robertson, T. et al Triton Systems, Inc.

Nov 01, 2021
9 Resources
0 Stars
Publicly accessible

TEAMER: Technical Support for Aquantis (Materials): CRD-21-17762-0

The Aquantis Tidal Power Tug is a unique synthesis of best-available technologies and materials configured as a novel spar vessel to create an optimal platform for tidal stream energy conversion. The Power Tug utilizes an upstream-facing horizontal, 2-bladed rotor. To drive down c...

Swales, H. et al Aquantis, Inc.

Oct 17, 2024
1 Resources
0 Stars
In curation

CalWave Open Water Demo Budget Period 1 Reports

The objective of the project is to advance the Technology Readiness Level (TRL) of the Wave Energy Converter (WEC) developed by CalWave Wave Power Technologies Inc (CalWave) through advanced numerical simulations, dynamic hardware tests, and ultimately a scaled open water demonstr...

Boerner, T. et al CalWave Power Technologies Inc.

Jun 03, 2019
8 Resources
0 Stars
Publicly accessible

Risk Management Plan and Risk Register for Design Low-Power Wave Energy Converter for Non-Grid Applications

Risk Registers for major subsystems completed according to the methodology described in the Risk Management Plan [DE-EE0008627 D1.2 Risk Management Plan PD v1.1 07-19-2019.pdf], also included here.

Amon, E. Columbia Power Technologies, Inc.

Jul 19, 2019
17 Resources
0 Stars
Publicly accessible

WEC-Sim Wave Energy Converter Simulator

WEC-Sim (Wave Energy Converter SIMulator) is an open-source wave energy converter (WEC) simulation tool. This repository includes: link to the WEC-Sim project website which includes, introductory and overview information about the WEC-Sim, WEC-Sim publications, release notes, li...

Lawson, M. National Renewable Energy Laboratory

Nov 25, 2014
2 Resources
0 Stars
In curation

TidGen: Single Turbine System (STS) Deployment and Mooring Report

This document provides a summary for the performance of the deployment and mooring systems for a single turbine test system (STS) deployed by the Ocean Renewable Power Company (ORPC) in Cobscook Bay, Maine in 2023.

Pillsbury, L. Ocean Renewable Power Company

Jan 05, 2024
1 Resources
0 Stars
Awaiting release

Advanced TidGen Power System Control and SCADA System

The TidGen Power System generates emission-free electricity from tidal currents and connects directly into existing grids using smart grid technology. The power system consists of three major subsystems: shore-side power electronics, mooring system, and turbine generator unit (TGU...

Marnagh, C. and McEntee, J. Ocean Renewable Power Company

Jun 14, 2018
2 Resources
0 Stars
Publicly accessible

RivGen Deployment Control System Specifications and Models, Igiugig, AK

Control System simulation models, case studies, and processing codes for analyzing field data. Raw data files included from VFD and SCADA. MatLab and Simulink are required to open some data files and all model files.

Forbush, D. et al Ocean Renewable Power Company

Mar 21, 2016
2 Resources
0 Stars
Publicly accessible

MASK2B Initial Results from Wave Tank Test of Closed-Loop WEC Control

This dataset covers the MASK2B wave tank experiment focused on a more complete study of one degree of freedom (1DOF) control of the WEC was considered, including maximization of electrical power, multi-objective performance mapping, and implementation of a novel predictionless con...

Coe, R. et al Sandia National Laboratories

May 25, 2018
3 Resources
0 Stars
Publicly accessible

TEAMER: Experimental Validation and Analysis of Deep Reinforcement Learning Control for Wave Energy Converters

Through this TEAMER project, Michigan Technological University (MTU) collaborated with Oregon State University (OSU) to test the performance of a Deep Reinforcement Learning (DRL) control in the wave tank. Unlike model-based controls, DRL control is model-free and can directly max...

Zou, S. et al Michigan Technological University

Mar 07, 2025
7 Resources
0 Stars
Curated

Control of an AUV with deployable energy-harvesting kite

This paper examines the control of an autonomous underwater vehicle (AUV) with a deployable energy-harvesting kite for oceanographic observation and surveillance. The proposed design and control strategies specifically address objectives of achieving high-payload, long-endurance A...

Reed, J. et al North Carolina State University

Sep 02, 2019
1 Resources
0 Stars
Publicly accessible

State Estimation for advanced control of wave energy converters

A report on state estimation for advanced control of wave energy converters (WECs), with supporting data models and slides from the overview presentation. The methods discussed are intended for use to enable real-time closed loop control of WECs.

Coe, R. and Bacelli, G. Sandia National Laboratories

Apr 25, 2017
6 Resources
0 Stars
Publicly accessible

RM3 Wave Tank Validation Model

An approximately 1/75th scale point absorber wave energy absorber was built to validate the testing systems of a 16k gallon single paddle wave tank. The model was build based on the RM3 design and incorporated a linear position sensor, a force transducer, and wetness detection sen...

Candon, C. and Fao, R. National Renewable Energy Laboratory

Jul 31, 2023
3 Resources
0 Stars
Publicly accessible

Coordinated Control of Tidal Cross-flow Turbines

Initial laboratory experiments with coordinated phase control of cross-flow turbines in a dense array.

Polagye, B. University of Washington

Dec 06, 2016
5 Resources
0 Stars
Publicly accessible

Holistic Control Embedded PTO Development Target Performance Metrics Definitions

Collection of Power Take-Off (PTO), Power Conversion Chain (PCC), and relevant device metrics to be used for performance assessment of the Control co-designed PTO including brief summary of literature, baseline, and target metrics values.

Boerner, T. et al CalWave Power Technologies Inc.

Jul 30, 2019
1 Resources
0 Stars
Publicly accessible

Direct-Drive Electrical Generator and PTO System for Flap-type Wave Energy Converters

Project and generator specifications and initial prototype test data for flap-type wave energy converters (WEC)

Englebretson, S. ABB Inc.

Mar 20, 2015
2 Resources
0 Stars
Publicly accessible

TEAMER: Cross-flow Turbine Hydrodynamics

The objective of this work is to validate RANS and LES computations of cross-flow turbine hydrodynamics using laboratory scale measurements. Validation involves the comparison of time-and phase averaged performance metrics and flowfields across the widest practical range of turbin...

Athair, A. et al University of Washington (NNMREC)

Mar 25, 2025
7 Resources
0 Stars
Curated

Wave Tank Testing Report for Controls Validation of a Heaving Point Absorber

The core objectives of this project is to improve the power capture of three different wave energy conversion (WEC) devices by more than 50% using an advanced control system and validate the attained improvements using wave tank and full scale testing. In parallel, we will bring a...

Previsic, M. et al Re Vision Consulting

Aug 26, 2020
3 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 Next >>