Search MHK Data

TEAMER: Additional Degree of Freedom for WEC Model

'Additional Degree of Freedom for WEC' WEC-Sim numerical model from RFTS 1 (request for technical support) TEAMER project. An increase in wave energy converter (WEC) efficiency requires not only consideration of the nonlinear effects in the WEC dynamics and the power take-off (PTO...

McCall, A. et al Dehlsen Associates, LLC

May 26, 2022
2 Resources
0 Stars
Awaiting release

WEC Controls Optimization Final Report

The over-arching project objective is to fully develop and validate optimal controls frameworks that can subsequently be applied widely to different WEC devices and concepts. Optimal controls of WEC devices represent a fundamental building block for WEC designers that must be cons...

Previsic, M. and Karthikeyan, A. Re Vision Consulting

Aug 26, 2020
1 Resources
0 Stars
Publicly accessible

SeaRAY WEC Preliminary Design and Test Planning

The SeaRAY is a deployable power system for maritime sensors, monitoring equipment, communications, unmanned underwater vehicles, and other similar payloads. This project is to design, deliver, and test a prototype low-power WEC that lowers the total cost of ownership and provides...

Hammagren, E. et al Columbia Power Technologies, Inc.

May 18, 2020
4 Resources
0 Stars
Awaiting release

StingRAY Updated WEC Risk Registers

Updated Risk Registers for major subsystems of the StingRAY WEC completed according to the methodology described in compliance with the DOE Risk Management Framework developed by NREL.

Rhinefrank, K. and Ondusko, M. Columbia Power Technologies, Inc.

Jun 27, 2018
17 Resources
0 Stars
Publicly accessible

2023 Risk Management Plan and Register for Low-Power WEC for Non-Grid Applications

This is an updated risk management plan and risk register for the design, build and test of a novel, remote, low-power wave energy converter (WEC) for non-grid applications. This Columbia Power Technologies project seeks to develop a prototype low-power WEC that lowers the total c...

Hammagren, E. et al Columbia Power Technologies, Inc.

Jun 14, 2023
17 Resources
0 Stars
Awaiting release

StingRAY Failure Mode, Effects and Criticality Analysis: WEC Risk Registers

Analysis method to systematically identify all potential failure modes and their effects on the Stingray WEC system. This analysis is incorporated early in the development cycle such that the mitigation of the identified failure modes can be achieved cost effectively and efficient...

Rhinefrank, K. Columbia Power Technologies, Inc.

Jul 25, 2016
18 Resources
0 Stars
Publicly accessible

Reference Model 3 Scaled Geometry (RM3: Wave Point Absorber)

Contains the Reference Model 3 (RM3) scaled scale geometry files of the Wave Point Absorber, developed by the Reference Model Project (RMP). These scaled geometry files are saved as SolidWorks assembly, IGS, and STEP files, and require a CAD program to view. The scaled RM3 device ...

Neary, V. et al Sandia National Laboratories

Sep 30, 2014
7 Resources
0 Stars
Publicly accessible

TEAMER: Results of Investigating Structural Design Concepts and Alternative Materials for a Wave Power System

Included here are materials from a study on the design of a three-body Wave Energy Converter (WEC) utilizing a heave plate, dual Power Take Offs (PTOs), and single point mooring. A material trade study has been conducted to evaluate the effects of introducing various metallic and ...

Whitney, C. et al Cardinal Engineering

Apr 27, 2024
4 Resources
0 Stars
Awaiting release

Triton Field Trials (TFiT) underwater noise University of New Hampshire Living Bridge turbine Processed Data

In July 2021, a commercial-off-the-shelf hydrophone was deployed in a free-drifting configuration to measure underwater acoustic emissions and characterize a 25 kW-rated tidal turbine at the University of New Hampshire's Living Bridge Project in Portsmouth, New Hampshire. Sampling...

Haxel, J. et al Pacific Northwest National Laboratory

Jul 21, 2021
6 Resources
1 Stars
Publicly accessible

Risk Management Plan and Risk Register for Design Low-Power Wave Energy Converter for Non-Grid Applications

Risk Registers for major subsystems completed according to the methodology described in the Risk Management Plan [DE-EE0008627 D1.2 Risk Management Plan PD v1.1 07-19-2019.pdf], also included here.

Amon, E. Columbia Power Technologies, Inc.

Jul 19, 2019
17 Resources
0 Stars
Publicly accessible

Aquantis 2.5 MW Ocean Current Generation Device Design Details

Items in this submission provide the detailed design of the Aquantis Ocean Current Turbine and accompanying analysis documents, including preliminary designs, verification of design reports, CAD drawings of the hydrostatic drivetrain, a test plan and an operating conditions simula...

Banko, R. et al Dehlsen Associates, LLC

Jun 03, 2015
22 Resources
0 Stars
Publicly accessible

ARIS Acoustic Camera Data Around a 5kW In-River Turbine from Tanana River Test Site

Four days (June 14-17, 2021) of ARIS acoustic camera data from the main research barge of the Tanana River Test Site operated by UAF. Data are collected sidelooking with the turbine in part of the field of view. This data was collected as part of a fish collision risk study. An ac...

Staines, G. Pacific Northwest National Laboratory

Jun 14, 2021
19 Resources
0 Stars
Publicly accessible

BOBr Raw Breaking Wave Data, Agate Beach, OR

Raw data from the BOBr (Buoy to Observe Breaking) wave measurement buoy. Data was recorded off the coast of Newport, OR at Agate Beach, in the surf zone.

C, A. Oregon State University

Oct 31, 2013
12 Resources
0 Stars
Publicly accessible

TEAMER: Cross-flow turbine

The objective of this work is to validate RANS and LES computations of cross-flow turbine hydrodynamics using laboratory scale measurements. Validation involves the comparison of time-and phase averaged performance metrics and flowfields across the widest practical range of turbin...

Athair, A. University of Washington (NNMREC)

Mar 25, 2025
4 Resources
0 Stars
In progress

National Marine Renewable Energy Center Upgrades LUPA

The data provided is part of a power take off damping optimization study. The power take off damping coefficient was swept from 0 to approximately 7000 N/m/s during a single regular wave test with a real time control of the motor/generator. The generated power from the LUPA (Lab U...

Robertson, B. et al Oregon State University

Oct 12, 2022
5 Resources
0 Stars
Publicly accessible

Oscylator-4 Energy Converter St. Clair River Installation Data 2016

Data collected during the 2016 St. Clair River installation of the Oscylator-4 energy converter.

Taipale, J. and Kim, E. Vortex Hydro Energy

Jul 20, 2016
30 Resources
0 Stars
Publicly accessible

Tanana River Transects August 2010

As part of the initial site investigation for the Tanana River near Nenana, Alaska, a set of transects was completed on August 10th, 2010. This data was collected with a Rio Grande 1200 Teledyne ADCP the same year the initial bathymetry was collected. This set of transects includ...

DUVOY, P. University of Alaska Fairbanks

Aug 10, 2010
5 Resources
0 Stars
Publicly accessible

Unobtrusive Multi-static Serial LiDAR Imager (UMSLI) Dataset at PNNL-Sequim Marine and Coastal Test Site

The dataset contains the data from the field deployment of the Unobtrusive Multi-static Serial LiDAR Imager (UMSLI) system at PNNL-Sequim test site in July 2017 and Oct-Nov 2017. UMSLI is developed at Harbor Branch Oceanographic Institute at Florida Atlantic University under DOE f...

Dalgleish, F. Florida Atlantic University

Sep 22, 2023
0 Resources
0 Stars
In progress

Next Generation RivGen Power System: Feasibility Assessment of Hydroacoutics Data for Development of a Probability of Encounter Model of Salmon Smolts

This document contains a feasibility assessment for salmon smolt characterization and analysis based on existing hydroacoustics data and probability of encounter model.

Daroux, A. and Zydlewski, G. Igiugig Village Council

Oct 04, 2017
1 Resources
0 Stars
Publicly accessible

ORPC TidGen Turbine Foil Production Process Technical Report

This report aims to provide a comprehensive overview of the production process for the first TidGen turbine. The turbine is composed of several key components, including carbon fiber foils, e-glass struts, and a steel shaft. The report covers the production of each of these elemen...

Barrington, M. Ocean Renewable Power Company

Jan 30, 2023
1 Resources
0 Stars
Awaiting release

Modeling the Integration of Marine Energy into Microgrids Wave Resource Assessment

This submission has wave resource assessments which were conducted for six locations based on IEC requirements using the DOE WPTO Hindcast data and MHKiT. The locations are chosen to provide varying wave climates and include PacWave South, OR; Wave Energy Testing Site (WETS), HI; ...

Mankle, H. and Robertson, B. University of Alaska Fairbanks

Jan 19, 2023
9 Resources
0 Stars
Publicly accessible

Design Specifications for Manufacturer for the HydroAir Power Take Off System

Includes Design Specs for Manufacturer, PTO Weight, PTO Dimensions, Turbine (Rotor and Ductwork) Design, CAD Drawings of the turbine and rotor, List of components and weights, Materials Used, Generator, List of components and weights, Structural Design, CAD drawings of the structu...

Natanzi, S. and Hall, R. Siemens Government Technologies, Inc.

Oct 02, 2020
1 Resources
0 Stars
Awaiting release

Timeseries Data from the Experimental Testing of the OPI's Prototype Hydraulic Drivetrain.

Timeseries data from the experimental testing of the OPI's prototype hydraulic drivetrain. The data is provided in .mat file format. The units for the data can be found in the ReadMe included in the submission resources.

Mundon, T. Oscilla Power, Inc.

Nov 26, 2021
4 Resources
0 Stars
Awaiting release

Performance Data from a 1-Meter Cross-flow Turbine with High Deflection Hydrofoils

Performance data of a 1-meter diameter cross-flow tidal turbine consisting of three NACA 0018 blades with two support struts with high deflection hydrofoils. Data was collected at the University of New Hampshire Jere A. Chase Ocean Engineering Lab within the tow tank. Three turbin...

Marone, N. et al University of New Hampshire, Atlantic Marine Energy Center (AMEC)

Jul 21, 2021
4 Resources
0 Stars
Publicly accessible

TEAMER: Numerical Model of IProTech PIP WEC Device

iProTech PIP wave energy converter (WEC) is a slack moored, single hull device with no moving parts in the water, joints or bearings. This submission includes data of the simulation, reports, and code for the iProTech PIP (WEC) project. The organization of the data included in the...

Ogden, D. et al IProTech

Nov 02, 2021
2 Resources
0 Stars
Publicly accessible

<< Previous 1 2 3 4 5 6 7 8 9 Next >>